HeatLink Group Inc.


Snow Melting

last page 1 2 3 4 5 next page

Consumer Frequently Asked Questions (FAQ)

1. Is it for you?
2. How much does it cost?
3. How much does it cost to operate?
4. What happens if a pipe breaks?
5. What runs through the pipes?
6. Does it heat up fast?


Q: Is it for you? ^
Snow melting can be very convenient. What you must decide is if this convenience is justified by the installation and operating costs. One consideration is if you have the boiler capacity or space for a boiler with enough capacity for snow melting. Another consideration is the type of system. A manual on/off system is the cheapest, but you must turn it on yourself and there will be a warm-up period before the snow melts. A semiautomatic system will turn itself on and off automatically and keep the area at a set temperature regardless of the presence or absence of snow or ice. A fully automatic system is the most convenient since it is always running and can detect the presence of snow and ice, however this system is the most expensive.

Q: How much does it cost? ^
The cost will vary depending on the project. Cost per square foot can run from about $8.00 US and up.

Q: How much does it cost to operate? ^
It depends on the type of system you have, how much snow melting area there is and the weather. A fully automatic system is more expensive to operate than a manual or semiautomatic system because it is continuously running on standby. The more snow melting area you have and the more snow there is, the higher the operating cost.

Q: What happens if a pipe breaks? ^
In the event that a problem occurs. HeatLink has a repair coupling that is used to repair the damage. Damage is very rare, but when it happens it usually happens during installation. The tubing is still exposed and repairs are made quickly and easily.

Q: What runs through the pipes? ^
A mixture of water and glycol would be used to prevent the pipes from freezing.

Q: Does it heat up fast? ^
It depends on the type of system you have and the weather. A manual system where the homeowner must turn it on will heat up slowly. A semiautomatic system will take the same amount of time to heat as a manual system, but the system will detect when to turn itself on. A fully automatic system will heat up quite fast since it will be running on standby all the time.


If you have questions or comments regarding this website please direct them to the webmaster.

Copyright ©2006 HeatLink Group Inc.

HeatLink and StatLink are registered trademarks of HeatLink Group Inc.
DryAbove, DryBelow, EndBend, SpacerClip, PexCube, and HeatSeal are trademarks of HeatLink Group Inc.